|
|
|
|
|
09-01-2010, 01:30 AM
|
#1 | ||
|
Starter Motor
Join Date: Nov 2009
Posts: 10
|
i have an au2 gas only when i start it cold i have to pump the accelerator afew times after it starts or it will stop has anyone got some advise beery.
|
||
|
|
|
09-01-2010, 01:51 AM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Dec 2004
Location: ACT
Posts: 4,028
|
When was the last time it was serviced?
Any other mods to the car? |
||
|
|
|
|
09-01-2010, 10:52 PM
|
#3 | ||
|
Moderator
  
Join Date: Feb 2005
Location: Kenthurst
Posts: 40,394
 
|
Could be issues with coolant flow to the converter.
When was the last time the thermostat was replaced ... do you have good condition coolant (and enough in it). Is the heater core blocked ... reducing the amount of coolant flowing into the converter???? Other things to check is if the idle jet in the converter is clear/clean ... so if there is junk around the solenoid plungers in the converter as well. Is the vehicle having issues cranking ... does it kick over after a couple of seconds or does it crank for longer??? Just a few questions really.
__________________
The Current Stable 2016 SZII TS Territory RWD Petrol The Evolution of the EGA54D utes AU Workshop Build thread of EGA54D B-Series Workshop Build thread of EGA54D 2004 SX TX Territory AWD - Gone but not forgotten 2010 FG XT "The ex-rental" - Moved onto a new home Mechan1k's Flickr Page |
||
|
|
|
|
03-02-2010, 02:21 AM
|
#4 | ||
|
Starter Motor
Join Date: Nov 2009
Posts: 10
|
thanks for that regards beery.
|
||
|
|
|
au2 cold starting gas only
Linear Mode
